Alumaloy, Ultrafuse Aluminum Repair, Durafix, Wizardweld

[Sandblaster]

Alumaloy, Ultrafuse Aluminum Repair, Durafix, Wizardweld, does this stuff work?

20140910_144129.jpg (545.05 KiB) Viewed 8058 times

What better way to test it then on a broken KX500 clutch cover...
In prep, I degreased it as best as I could.
Then I used a simple Map Gas torch and heated the cover until the seal around the oil level window started smoking
Then I took the aluminum rod and touched it to the crack, not into the flame of the torch.
The rod started to flow so I moved the rod along and filled the cracks.

The results? Good as new?

20140910_144533.jpg (616.83 KiB) Viewed 8057 times

The cracks are filled and it looks ok but how to test it?
I filled the cover full of water and it didn't leak...
But what about a strength or endurance test?
I'll see what I can come up with...

[Sandblaster]

One thing I have learned is that once the rod has been applied, you can't heat it again to smooth it out.
For some reason the stuff balls up and doesn't stick again.

[Sandblaster]

Another thing... a propane torch doesn't get the material to be fixed hot enough to melt the rod.... at least not easily.
A Map gas torch is no problem.